
Harco electric 5 tons actuator
Type: | Linear force (N) | Speed (mm/s) | stroke (mm) | Supply voltage |
---|---|---|---|---|
HCK16L | 0-13.200 * | 0-300 | 50-1000 (720N @., 1000mm stroke) | 24-48VDC 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCK20L | 0-15.000 | 0-300 | 50-1000 (1721N @ 1000mm stroke) | 24-48VDC 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCK25L | 0-17.000 | 0-300 | 50-1000 (5440N @1000mm stroke) | 24-48VDC 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCK32L | 0-28.000 | 0-300 | 50-1500 (10000N@ 1500mm stroke) | 24-48VDC 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCK40L | 0-50.000 | 0-300 | 50-1500 (20.000N @ 1500mm stroke) | 24-48VDC 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCK50L | 0-58.000 | 0-300 | 50-1500 (40.000N @ 1500mm stroke) | 1x230VAC 3x400-440VAC, 50/ 60HZ |
HCKXXL on request | 150.000 | 0-150 | 50-1500 | 1x230VAC 3x400-440VAC, 50/ 60HZ |
Ambient temperature operation -10-45 degrees Celsius
High speed and low load operation up to 300mm/s
- Position feed back
- Precise position and force feedback (Force in % of max force)
- Prepared for battery operation
- PTC protection drive motors
- PT100 temperature sensor in motor windings for continuous monitoring
- Standby heating
- Surface treatment C5-m or Norsok M502 system
- Built in motor
- Stroke 2000mm or longer on request depending on load scenario
- Stainless steel or duplex
Options
- Spherical bearing - both ends (Only with built in motor)
- Spherical bearing – threaded rod end (Only with built in motor)
- Front flange – spherical bearing rod end
- Front flange – threaded rod end
- Trunnion mounting – spherical bearing rod end
- Trunnion mounting – threaded rod end
- Bottom flange – spherical bearing rod end
- Bottom flange – threaded rod end
Interface
Cycle test with data sampling:
- Torque
- Power
- Speed
- Number of cycles
- Bearing and motor temperature
HARCO 30 ton electric actuator


- Heavy duty units
- Applicable for On- and Offshore operation
- AC or DC operation
- High efficiency low power consumption
- Same force in both direction
- Regeneration up to 70% of applied power
- 150.000 cycle test no measurable wear
- Minimum maintenance
- Low installation cost
- Low noise
- High speed
- Regeneration module for high load braking
- UPS Battery back up
- Battery operation with regeneration
- Ethernet tcp/ip control and monitoring with Harco drive system
- Rod 20MnV6 with min. 20μ hard chrome or stainless steel